M34513E4SP/FP 데이터 시트보기 (PDF) - Renesas Electronics

부품명

상세내역

일치하는 목록

M34513E4SP/FP

SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER

Renesas Electronics 

MITSUBISHI MICROCOMPUTERS

4513/4514 Group

SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER

(8) Program counter (PC)

Program counter (PC) is used to specify a ROM address (page and

address). It determines a sequence in which instructions stored in

ROM are read. It is a binary counter that increments the number of

instruction bytes each time an instruction is executed. However,

the value changes to a specified address when branch instructions,

subroutine call instructions, return instructions, or the table refer-

ence instruction (TABP p) is executed.

Program counter consists of PCH (most significant bit to bit 7)

which specifies to a ROM page and PCL (bits 6 to 0) which speci-

fies an address within a page. After it reaches the last address

(address 127) of a page, it specifies address 0 of the next page

(Figure 7).

Make sure that the PCH does not specify after the last page of the

built-in ROM.

(9) Data pointer (DP)

Data pointer (DP) is used to specify a RAM address and consists

of registers Z, X, and Y. Register Z specifies a RAM file group, reg-

ister X specifies a file, and register Y specifies a RAM digit (Figure

8).

Register Y is also used to specify the port D bit position.

When using port D, set the port D bit position to register Y certainly

and execute the SD, RD, or SZD instruction (Figure 9).

Program counter

p6 p5 p4 p3 p2 p1 p0 a6 a5 a4 a3 a2 a1 a0

PCH

Specifying page

PCL

Specifying address

Fig. 7 Program counter (PC) structure

Data pointer (DP)

Z1 Z0 X3 X2 X1 X0 Y3 Y2 Y1 Y0

Register Y (4) Specifying

RAM digit

Register X (4)

Specifying RAM file

Register Z (2)

Specifying RAM file group

Fig. 8 Data pointer (DP) structure

Specifying bit position

Set

0 1 01

Register Y (4)

D7 D6 D5 D4 D0

1

Port D output latch

Fig. 9 SD instruction execution example

17

Share Link: