L9825 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

일치하는 목록

L9825

Octal Low-side Driver For Resistive and Inductive Loads With Serial / Parallel Input Control, Output Protection and Diagnostic

STMicroelectronics 

Figure 2. Output Control register structure

MSB

LSB

Q2 Q4 Q6 Q8 Q1 Q3 Q5 Q7

L9825

Control-bit output 7

Control-bit output 5

Control-bit output 3

Control-bit output 1

Control-bit output 8

Control-bit output 6

Control-bit output 4

Control-bit output 2

Power outputs characteristics for flyback current, outputs short circuit protection and diagnostics

For output currents flowing into the circuit the output voltages are limited. The typical value of this voltage is 50V.

This function allows that the flyback current of a inductive load recirculates into the circuit; the flyback energy is

absorbed in the chip.

Output short circuit protection for outputs 1 to 6 (dedicated for loads without inrush current): when the output

current exceeds the short circuit threshold, the corresponding output overload latch is set and the output is

switched off immediately.

Output short circuit protection for outputs 7 and 8 (dedicated for loads with inrush current, as lamps): when the

load current would exceed the short circuit limit value, the corresponding output goes in a current regulation

mode. The output current is determined by the output characteristics and the output voltage depends on the

load resistance. In this mode high power is dissipated in the output transistor and its temperature increases rap-

idly. When the power transistor temperature exceeds the thermal shutdown threshold, the overload latch is set

and the corresponding output switched off.

For the load diagnostic in output off condition each output features a diagnostic current sink, typ 60µA.

Diagnostics

The output voltage at all outputs is compared with the diagnostic threshold, typ 0.38 · VCC.

Outputs 1 and 2 features dedicated fault latches. The output status signal is filtered and latched. The fault latch-

es are cleared during NCS low. The latch stores the status bit, so the first reading after the error occurred might

be wrong. The second reading is right.

Table 2. Diagnostic for outputs 1 and 2 in parallel controlled mode.

Output 1, 2

Output-voltage

Status-bit

off

> DG-threshold

high

off

< DG-threshold

low

on

< DG-threshold

high

on

> DG-threshold

low

Output-mode

correct operation

fault condition 2)

correct operation

fault condition 1)

Fault condition 1) "output short circuit to Vbat" : the output was switched on and the voltage at the output ex-

ceeded the diagnostics threshold due to overcurrent, the output overload latch was set and the output has been

switched off. The diagnostic bit is low.

7/11

Share Link: