L5961
2
Functionality details
Functionality details
● Provides three basic states:
– Zero power mode
All external HW is switched off. PM-chip is switched Off except "REG1 voltage
regulator", "Switch-to-power-pulse comparator" and "Control logic".
– Ultra zero power mode
All external HW is switched off. PM-chip is switched Off except "ON/OFF Control
logic". PMD can be woken up to reach "Zero current mode" by activities on
DIAG_I/O line
– Normal
PMD and external HW is powered. One of the four possible wake-up conditions
occurs and the wake-up event is confirmed either by means of PWROFF pin or
I2C bus.
To confirm the on-event:
- PWROFF pin must be driven low OR
- the right I2C bus command is provided.
● Reacts on four different wake-up events
– Switch to power pulse (STPP)
– Light ON (for status)
– Activity on Diag_I/O
– ON/OFF switch
● I2C interface (allowing system programmability)
● Generation of switch to power pulse (STPP)
● Online battery monitoring, reacts on battery changes/ events:
– Over voltage
– Critical voltage
– Under voltage
● Hardware watchdog triggered with discrete input, available to monitor the activity of the
controller
● Fail-safe behavior:
– Intrinsic filtering time of wake-up events
– Protection against software caused failures
– Over-temperature warning / thermal protection
● Diagnostic transceiver compatible to standard LIN2.0
3/7