L4938ED 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

일치하는 목록

L4938ED

Advanced voltage regulator

STMicroelectronics 

L4938ED, L4938EPD

Application information

The value of the programming resistor RPR can be calculated with:

RPR = --4V------.---R7-2------K2-T------K--–----1-- – 92.9K

3.8V ≤ VRT ≤ 4.7V

The reset pulse delay time tRD, is defined with the charge time of an external capacitor CT:

tRDmin = -C----T--1---⋅-μ--0--A-.--6---V---

tRDnom = C-----T--1---⋅-μ--1--A-.--4---V---

The reaction time of the reset circuit originates from the noise immunity. Standby output

voltage drops below the reset threshold only a bit longer than the reaction time results in a

shorter reset delay time. The nominal reset delay time is generated for standby output

voltage drops longer than approximately 50 µs. The minimum reset time is generated if

reset condition only occurs for a short time triggering a reset pulse but not completely

discharging CT. The reset can be related to output2 on request. If higher charge currents for

the reset capacitor are required a resistors from pin CT to OUT1, may be used to increase

the current. We recommended the use of 10 KΩ to 5 V as an output pull up.

3.5

Sense comparator

The sense comparator compares an input signal with an internal voltage reference of typical

1.23 V. The use of an external voltage divider makes this comparator very flexible in the

application. It can be used to supervise the input voltage either before or after the protection

diode and to give additional information to the microprocessor like low voltage warnings. We

recommended the use of 10 KΩ to 5 V as an output pull up.

3.6

Thermal protection

Both outputs are provided with an overtemperature shutdown regulation power dissipation

down to uncritical values. Output 2 shuts down approximately 10 K before output 1. Under

normal conditions shutdown of output 2 allows the chip to cool down again. Thus output 1 is

unaffected. The thermal shutdown reduces the output voltages until power dissipation and

the flow of thermal energy out of the chip balance.

3.7

Transient sensitivity

In proper operation (VOUT > 4.5 V) the reference is supplied by VOUT1 thus reducing

sensitivity to input transients.

a. The reference is alternatively supplied from VS or VOUT1. If one supply is present, the reference is operating.

Doc ID 17243 Rev 2

13/20

Share Link: