IR3086 데이터 시트보기 (PDF) - International Rectifier
부품명
상세내역
일치하는 목록
IR3086 Datasheet PDF : 15 Pages
| |||
IR3086
SYSTEM THEORY OF OPERATION
XPhaseTM Architecture
The XPhaseTM architecture is designed for multiphase interleaved buck converters which are used in applications
requiring small size, design flexibility, low voltage, high current and fast transient response. The architecture can be
used in any multiphase converter ranging from 1 to 16 or more phases where flexibility facilitates the design trade-off
of multiphase converters. The scalable architecture can be applied to other applications which require high current or
multiple output voltages.
As shown in Figure 1, the XPhaseTM architecture consists of a Control IC and a scalable array of phase converters
each using a single Phase IC. The Control IC communicates with the Phase ICs through a 5-wire analog bus, i.e. bias
voltage, phase timing, average current, error amplifier output, and VID voltage. The Control IC incorporates all the
system functions, i.e. VID, PWM ramp oscillator, error amplifier, bias voltage, and fault protections etc. The Phase IC
implements the functions required by the converter of each phase, i.e. the gate drivers, PWM comparator and latch,
over-voltage protection, and current sensing and sharing.
There is no unused or redundant silicon with the XPhaseTM architecture compared to others such as a 4 phase
controller that can be configured for 2, 3, or 4 phase operation. PCB Layout is easier since the 5 wire bus eliminates
the need for point-to-point wiring between the Control IC and each Phase. The critical gate drive and current sense
connections are short and local to the Phase ICs. This improves the PCB layout by lowering the parasitic inductance
of the gate drive circuits and reducing the noise of the current sense signal.
POWER GOOD
PHASE FAULT
VR HOT
12V
ENABLE
VID5
VID0
VID1
VID2
VID3
VID4
IR3081
CONTROL
IC
>> BIAS VOLTAGE
>> PHASE TIMING
<< CURRENT SENSE
>> PWM CONTROL
>> VID VOLTAGE
PHASE FAULT
CURRENT SHARE
PHASE HOT
IR3086
PHASE
IC
0.1uF
CCS RCS
CIN
COUT
VOUT SENSE+
VOUT+
VOUT-
VOUT SENSE-
PHASE FAULT
CURRENT SHARE
PHASE HOT
IR3086
PHASE
IC
0.1uF
CCS RCS
Page 6 of 15
CONTROL BUS
ADDITIONAL PHASES
INPUT/OUTPUT
Figure 1 – System Block Diagram
9/1/03
Share Link: 