TDA3661A 데이터 시트보기 (PDF) - Philips Electronics

부품명

상세내역

일치하는 목록

TDA3661A

Very low dropout voltage/quiescent current adjustable voltage regulator

Philips Electronics 

Philips Semiconductors

TDA3661

Very low dropout voltage/quiescent current voltage regulator

[4] These packages are not suitable for wave soldering. On versions with the heatsink on the bottom side, the

solder cannot penetrate between the printed-circuit board and the heatsink. On versions with the heatsink

on the top side, the solder might be deposited on the heatsink surface.

[5] If wave soldering is considered, then the package must be placed at a 45° angle to the solder wave

direction. The package footprint must incorporate solder thieves downstream and at the side corners.

[6] Wave soldering is suitable for LQFP, QFP and TQFP packages with a pitch (e) larger than 0.8 mm; it is

definitely not suitable for packages with a pitch (e) equal to or smaller than 0.65 mm.

[7] Wave soldering is suitable for SSOP, TSSOP, VSO and VSSOP packages with a pitch (e) equal to or larger

than 0.65 mm; it is definitely not suitable for packages with a pitch (e) equal to or smaller than 0.5 mm.

[8] Image sensor packages in principle should not be soldered. They are mounted in sockets or delivered

pre-mounted on flex foil. However, the image sensor package can be mounted by the client on a flex foil by

using a hot bar soldering process. The appropriate soldering profile can be provided on request.

[9] Hot bar soldering or manual soldering is suitable for PMFP packages.

9397 750 15049

Product data sheet

Rev. 05 — 28 June 2005

© Koninklijke Philips Electronics N.V. 2005. All rights reserved.

13 of 16

Share Link: