HSP061-2M6(2012) 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

일치하는 목록

HSP061-2M6
(Rev.:2012)

2-line ESD protection for high speed lines

STMicroelectronics 

Recommendation on PCB assembly

HSP061-2

4. 3.5 N placement force is recommended. Too much placement force can lead to

squeezed out solder paste and cause solder joints to short. Too low placement force

can lead to insufficient contact between package and solder paste that could cause

open solder joints or badly centered packages.

5. To improve the package placement accuracy, a bottom side optical control should be

performed with a high resolution tool.

6. For assembly, a perfect supporting of the PCB (all the more on flexible PCB) is

recommended during solder paste printing, pick and place and reflow soldering by

using optimized tools.

4.4

PCB design preference

1. To control the solder paste amount, the closed via is recommended instead of open

vias.

2. The position of tracks and open vias in the solder area should be well balanced. The

symmetrical layout is recommended, in case any tilt phenomena caused by

asymmetrical solder paste amount due to the solder flow away.

4.5

Reflow profile

Figure 20. ST ECOPACK® recommended soldering reflow profile for PCB mounting

Temperature (°C)

260°C max

255°C

220°C

180°C

125 °C

3°C/s max

3°C/s max

2°C/s62r°°eCCc//ossm6mr°emCacx/eosnmmdmeadxended

0

0

1

2

3

4

5

6

7

10-30 sec

Time (min)

90 to 150 sec

90 sec max

Note:

Minimize air convection currents in the reflow oven to avoid component movement.

10/12

Doc ID 022777 Rev 1

Share Link: