SL2017MP1S 데이터 시트보기 (PDF) - Mitel Networks

부품명

상세내역

일치하는 목록

SL2017MP1S

Full Band Satellite Tuner

Mitel Networks 

SL2017

Measurement of IM3 and IP3

a) Input two signal tones from RF generators. The level of

these should be adjusted so that the device sees an input

signal level of -19dBm from each tone.

Program the local oscillator so that both tones are mixed down

to the IF (approx).

b) Adjust the AGC so that the device gives an overall

conversion gain of +5dB.

c) Connect a spectrum analyser to the selected IF output of

the device.

d) Measure the relative levels of the down converter signals

and the 3rd order products (see diag overleaf).

Two input signals are used:

f1 = 950MHz

f2 = 951MHz

The local oscillator flo is tuned to 1430MHz.

This gives the following at the IF output:

fa = 1430MHz - 950MHz = 480MHz

fb = 1430MHz - 951MHz = 479MHz

e) The difference in level in dB between the fundamentals and

the 3rd order products is the IM3 of the device.

f) IP3 may be calculated from the above reading as follows:

IP3 = RF input level + IM3/2.

This level is usually referred to the input.

e.g.

Assuming a measured IM3 of 44dB, and with an input level of

-19dBm,

IP3 = 44/2 + -19dBm = +3dBm

In a 50Ω system, this may be converted to dBuV by adding 107

to the value calculated since 0dBm = 107dBµV.

i.e. +3dBm = 110dBuV.

This is known as the input referred IP3 of the device.

If you experience any difficulties with this board, or require

further help, please contact Robert Marsh on 01793 518234

or Fred Herman on 01793 518423. The fax number is 01793

518411.

Mixing products are also produced in the front end. These

are then downconverted by the mixer.

The in-band ones are listed below:

fd = flo - (2 x f1 - f2)

fc = flo - (2 x f2 - f1)

fd = 1430MHz - (2 x 950MHz - 951MHz) = 481MHz

fc = 1430MHz - (2 x 951MHz - 950MHz) = 478MHz

fundamentals

3rd order product

3rd order product

fc fa fb fd

10

Share Link: