GM6605-A 데이터 시트보기 (PDF) - Unspecified
부품명
상세내역
일치하는 목록
GM6605-A Datasheet PDF : 9 Pages
| |||
GM6605
APPLICATION INFORMATION
The GM6605 series linear regulators provide fixed and Protection Diodes
adjustable output voltages at currents up to 5.0A.
These regulators are protected against overcurrent con-
ditions and include thermal shutdown protection. The
GM6605's have a composite PNP-NPN output transis-
tor and require an output capacitor for stability.
When large external capacitors are used with most
linear regulator it is wise to add protection diodes. If
the input voltage of the regulator is shorted, the out-
put capacitor will discharge into the output of the reg-
ulator. The discharge current depends on the value
A detailed procedure for selecting this capacitor fol- of capacitor, output voltage and rate at which VIN
lows.
drops.
Stability Considerations
(a),(b)
Figure 1 Protection Diode Scheme for
Large Output Capacitors
(a) Fixed Version
The output compensation capacitor helps to determine
three main characteristics of a linear regulator's perfor-
mance: start-up delay, load transient response, and
loop stability. The capacitor value and type is based on
cost, availability, size and temperature constraints. A
tantalum or aluminum electrolytic capacitor is pre-
ferred, as a film or ceramic capacitor with almost zero
ESR can cause instability. An aluminum electrolytic ca-
VIN
C1
IN4002
VIN
VOUT
GM6605-3.3
GND
VOUT
C2
pacitor is the least expensive type, but when the circuit
operates at low temperatures, both the value and ESR
of the capacitor will vary widely. For optimum perfor-
mance over the full operating temperature range, a tan-
talum capacitor is best. A 22µF tantalum capacitor will
work fine in most applications, but with high current reg-
ulators such as the GM6605 higher capacitance values
will improve the transient response and stability. Most
applications for the GM6605's involve large changes in
(b) Adjustable Version
VIN
C1
IN4002
VIN
VOUT
GM6605-Adj
ADJ
VOUT
R1 C2
load current, so the output capacitor must supply in-
stantaneous load current. The ESR of the output ca-
CADJ
R2
pacitor causes an immediate drop in output voltage
given by:
DV = DI x ESD
In the GM6605 linear regulators, the discharge path
In microprocessor applications an output capacitor net-
work of several tantalum and ceramic capacitors in par-
allel is commonly used. This reduces overall ESR and
minimizes the instantaneous output voltage drop under
transient load conditions. The output capacitor network
should be placed as close to the load as possible for
is through a large junction, and protection diodes are
normally not needed. However, if the regulator is
used with large output capacitance values and the in-
put voltage is instantaneously shorted to ground,
damage can occur. In this case, a diode connected
as shown above in Figure 1.
the best results.
5
Share Link: 