MAX3220ACAP 데이터 시트보기 (PDF) - Maxim Integrated

부품명

상세내역

일치하는 목록

MAX3220ACAP

3V to 5.5V, up to 250kbps True RS-232 Transceiver with 4µA AutoShutdown Plus and Power-On Reset

Maxim Integrated 

3V to 5.5V, up to 250kbps True RS-232 Transceiver

with 4µA AutoShutdown Plus and Power-On Reset

RECEIVER

INPUTS

VOLTAGE

INVALID

REGION

* **

TRANSMITTER

INPUTS

VOLTAGE

TRANSMITTER

OUTPUTS

VOLTAGE

INVALID VCC

OUTPUT

0 INVL

V+

tAUTOSHDN

VCC

0

V-

* ALL RECEIVER/TRANSMITTER INPUTS INACTIVE

** ANY ONE RECEIVER/TRANSMITTER INPUT BECOMES ACTIVE

Figure 3a. AutoShutdown Plus and INVALID Timing Diagram

INVALID HIGH

2.7V

INDETERMINATE

0.3V

0V

INVALID LOW

-0.3V

INDETERMINATE

-2.7V

INVALID HIGH

Figure 3b. Receiver Positive/Negative Thresholds for INVALID

__________Applications Information

Ensuring a Valid Reset Output

Down to VCC = 0V

When VCC falls below 1V, RESET no longer sinks cur-

rent: it becomes an open circuit. Therefore, high-

impedance CMOS logic inputs connected to RESET

tAUTOSHDN

tWU

tWU

FORCEON = GND, FORCEOFF = VCC

can drift to undefined voltages. This presents no prob-

lem in most applications, since most µPs and other cir-

cuitry is inoperative with VCC below 1V. However, in

applications where RESET must be valid down to 0V,

add a pull-down resistor to ground, holding RESET low

(Figure 4). R1’s value is not critical; 100kΩ is large

enough not to load RESET, and small enough to pull it

to ground.

Capacitor Selection

The capacitor type used for C1–C4 is not critical for

proper operation; use either polarized or nonpolarized

capacitors. The charge pump requires 0.1µF capaci-

tors for 3.3V operation. For other supply voltages, refer

to Table 3 for required capacitor values. Do not use val-

ues smaller than those listed in Table 3. Increasing the

capacitor values (e.g., by a factor of 2) reduces ripple

on the transmitter outputs and slightly reduces power

consumption. C2, C3, and C4 can be increased without

changing C1's value. However, do not increase C1

without also increasing the values of C2, C3, C4,

and CBYPASS, to maintain the proper ratios (C1 to

the other capacitors).

8 _______________________________________________________________________________________

Share Link: