datasheetbank_Logo
전자부품 반도체 검색엔진( 무료 PDF 다운로드 ) - 데이터시트뱅크

EBE21FD4AHFL 데이터 시트보기 (PDF) - Elpida Memory, Inc

부품명
상세내역
일치하는 목록
EBE21FD4AHFL
Elpida
Elpida Memory, Inc Elpida
EBE21FD4AHFL Datasheet PDF : 22 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
EBE21FD4AHFT, EBE21FD4AHFE, EBE21FD4AHFL
Electrical Specifications
All voltages are referenced to VSS (GND).
Absolute Maximum Ratings
Parameter
Voltage on any pin relative to VSS
AMB core power voltage relative to VSS
DRAM interface power voltage relative to VSS
Termination voltage relative to VSS
Storage temperature
Symbol
VIN/VOUT
VCC
VDD
VTT
Tstg
Value
–0.3 to +1.75
–0.3 to +1.75
–0.5 to +2.30
–0.5 to +2.30
–55 to +100
Unit
Note
V
V
V
V
°C
Caution
Exposing the device to stress above those listed in Absolute Maximum Ratings could cause
permanent damage. The device is not meant to be operated under conditions outside the limits
described in the operational section of this specification. Exposure to Absolute Maximum Rating
conditions for extended periods may affect device reliability.
Operating Temperature Conditions
Parameter
Symbol
Value
Unit
Note
SDRAM component case temperature
TC_DRAM
0 to +95
°C
1
AMB component case temperature
TC_AMB
110
°C
Note: 1. Supporting 0°C to +85°C and being able to extend to +95°C with doubling auto-refresh commands in
frequency to a 32ms period (tREFI = 3.9µs) and higher temperature self-refresh entry via the control of
EMRS (2) bit A7 is required.
DC Operating Conditions
Parameter
Symbol
min.
typ.
max.
Unit
Note
AMB supply voltage
VCC
1.455
1.50
1.575
V
DDR2 SDRAM supply voltage VDD
1.7
1.8
1.9
V
Input termination voltage
VTT
0.48 × VDD 0.50 × VDD 0.52 × VDD
V
EEPROM supply voltage
VDDSPD
3.0
3.3
3.6
V
SPD input high voltage
VIH (DC)
2.1
VDDSPD
V
1
SPD input low voltage
VIL (DC)
0.8
V
1
RESET input high voltage
VIH (DC)
1.0
V
2
RESET input low voltage
VIL (DC)
0.5
V
2
Leakage current (RESET)
IL
–90
90
µA
2
Leakage current (link)
IL
–5
5
µA
3
Notes: 1. Applies for SMB and SPD bus signals.
2. Applies for AMB CMOS signal /RESET.
3. For all other AMB related DC parameters, please refer to the high-speed differential link interface
specification.
Preliminary Data Sheet E1001E30 (Ver. 3.0)
10

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]