DS1230AB 데이터 시트보기 (PDF) - Dallas Semiconductor -> Maxim Integrated

부품명

상세내역

일치하는 목록

DS1230AB

256k Nonvolatile SRAM

Dallas Semiconductor -> Maxim Integrated 

POWER-DOWN/POWER-UP TIMING

PARAMETER

SYMBOL

CE, at VIH before Power-Down

tPD

VCC slew from VTP to 0V ( CE at VIH)

tF

VCC slew from 0V to VTP ( CE at VIH)

tR

CE at VIH after Power-Up

tREC

MIN

0

300

300

2

TYP

DS1230Y/AB

(tA: See Note 10)

MAX UNITS NOTES

µs

11

µs

µs

125

ms

PARAMETER

Expected Data Retention Time

SYMBOL MIN TYP

tDR

10

MAX

(tA=25°C)

UNITS NOTES

years

9

WARNING:

Under no circumstance are negative undershoots, of any amplitude, allowed when device is in battery

backup mode.

NOTES:

1. WE is high for a Read Cycle.

2. OE = VIH or VIL. If OE = VIH during write cycle, the output buffers remain in a high-impedance state.

3. tWP is specified as the logical AND of CE and WE . tWP is measured from the latter of CE or WE

going low to the earlier of CE or WE going high.

4. tDH, tDS are measured from the earlier of CE or WE going high.

5. These parameters are sampled with a 5 pF load and are not 100% tested.

6. If the CE low transition occurs simultaneously with or latter than the WE low transition, the output

buffers remain in a high-impedance state during this period.

7. If the CE high transition occurs prior to or simultaneously with the WE high transition, the output

buffers remain in high-impedance state during this period.

8. If WE is low or the WE low transition occurs prior to or simultaneously with the CE low transition,

the output buffers remain in a high-impedance state during this period.

9. Each DS1230Y has a built-in switch that disconnects the lithium source until VCC is first applied by

the user. The expected tDR is defined as accumulative time in the absence of VCC starting from the

time power is first applied by the user.

10. All AC and DC electrical characteristics are valid over the full operating temperature range. For

commercial products, this range is 0°C to 70°C. For industrial products (IND), this range is -40°C to

+85°C.

11. In a power-down condition the voltage on any pin may not exceed the voltage on VCC.

12. tWR1 and tDH1 are measured from WE going high.

13. tWR2 and tDH2 are measured from CE going high.

14. DS1230 DIP modules are recognized by Underwriters Laboratory (U.L.) under file E99151.

DS1230 PowerCap modules are pending U.L. review. Contact the factory for status.

8 of 12

Share Link: