DF37 데이터 시트보기 (PDF) - HIROSE ELECTRIC

부품명

상세내역

일치하는 목록

DF37

0.4 mm Pitch, 0.98 mm Mated Height, Board-to-Board / Board-to-FPC Connectors

HIROSE ELECTRIC 

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

DF37 Seriesq0.4 mm Pitch, 0.98 mm Mated Height, Board-to-Board / Board-to-FPC Connectors

BHandling Precautions When Un-mating Connectors

DF37*-*DP-0.4V

Header

DF37*-*DS-0.4V

Receptacle

Fully mated

Lift even, keeping both connectors parallel to

each other

Pitch orientation

Corner orientation

Width orientation

When handling, circumstances may prevent

the connectors from being kept parallel when

un-mating. One end may be lifted as shown.

However, to use this procedure the connector

must be mounted on sufficiently rigid circuit

board.

Any deflection of the board during this opera-

tion may result in damage to the connector or

solder joints.

Do not attempt to start the un-mating of the

connectors from one side or corner.

Failure to exercise caution when un-mating

the connectors mounted on the non-rigid FPC

may also result in connector breakage.

It is the responsibility of the user to perform

verification of the repeated mating / un-mating

cycles with the connectors mounted on the

applicable FPC.

When the rigidity of the FPC is low, there is a

risk that the connector could break as illustrat-

ed in the diagram at left.

Please use the connectors after performing a

check of repeated operation with the FPC that

the customer will be using.

Evaluative results of FPC rigidity and various

items are available. Please inquire.

120

Share Link: