PI3B16215B 데이터 시트보기 (PDF) - Pericom Semiconductor
부품명
상세내역
일치하는 목록
PI3B16215B Datasheet PDF : 5 Pages
| |||
PI3B16215
3.3V, Hot Insertion,
1122334455667788990011223344556677889900112233445566778899001122112233445566778899001122334455667788990011223344556677889900112211223344556677889900112233445566778829900011-22B3344i55t66F7788E9900T1122B1122u3344s55S6677w8899i00t11c22h3344w556677/88P99r0011e22c33h4455a6677r88g9900e11d2211O2233u4455t66p7788u9900t11s22
Switching Characteristics over Operating Range
(Switching characteristics over recommended operating free-air temperature range unless otherwise noted)
Parameter
tPD(1)
tPZH
Test Conditions
BIASV = GND
From (Input)
A or B
To (Output)
B or A
VCC = 3.3V ±10%
Min.
Max.
0.25
4.5
tPZL
BIASV = 3V
4.5
OE
A or B
tPHZ
BIASV = GND
5.0
tPLZ
BIASV = 3V
5.0
Note:
1. The propagation delay is the calculated RC time of the typical on-state resistance of the switch and the specified load
capacitance, when driven by an ideal voltage source (zero output impedance).
Units
ns
Parameter Measurements (VCC = 2.7 and 3.3V ±10%)
Test
tPD
tPLZ/tPZL
tPHZ/tPZH
S1
Open
6V
GND
Voltage Waveforms Propagation Delay Times
Voltage Waveforms Enable and Disable Times
Notes:
Figure 2. Load Circuit and Voltage Waveforms
1. CL includes probe and jig capacitance.
2. Waveform 1 is for an output with internal conditions such that the output is low except when disabled by the output control.
Waveform 2 is for an output with internal conditions such that the output is high except when disabled by the output control.
3. All input impulses are supplied by generators having the following characteristics: PRR ≤ MHz, ZO = 50Ω, tR ≤ 2.5ns, tF ≤ 2.5ns.
4. The outputs are measured one at a time with one transition per measurement.
5. tTPZ and tPHZ are the same as tDIS
6. tPZL and tPZH are the same as tEN
7. tPLH and tPHL are the same as tPD
3
PS8190D
05/04/00
Share Link: 