BD5340FVE 데이터 시트보기 (PDF) - ROHM Semiconductor
부품명
상세내역
일치하는 목록
BD5340FVE Datasheet PDF : 10 Pages
| |||
BD52□□G, BD52□□FVE, BD53□□G, BD53□□FVE series
Circuit Applications
1) Examples of a common power supply detection reset circuit
Technical Note
VDD1
VDD2
RL
BD52□□□
Microcontroller
CT
CL
（Noise-filtering
Capacitor）
）
Fig.18 Open Collector Output Type
GND
Application examples of BD52□□G/FVE series (Open
Drain output type) and BD53□□G/FVE series (CMOS
output type) are shown below.
CASE1: the power supply of the microcontroller (VDD2)
differs from the power supply of the reset detection
(VDD1).
Use the open drain output type (BD52□□G/FVE) attached
a load resistance (RL) between the output and VDD2. (As
shown Fig.15)
VDD1
CT
GND
BD53□□□
Microcontroller
CL
（Noise-filtering
Capacitor）
CASE2: the power supply of the microcontroller (VDD1) is
same as the power supply of the reset detection (VDD1).
Use CMOS output type (BD53□□G/FVE) or open drain
output type (BD52□□G/FVE) attached a load resistance
(RL) between the output and Vdd1. (As shown Fig.16)
When a capacitance CL for noise filtering is connected to
the VOUT pin (the reset signal input terminal of the
microcontroller), please take into account the waveform of
the rise and fall of the output voltage (VOUT).
Fig.19 CMOS Output Type
2) The following is an example of a circuit application in which an OR connection between two types of detection voltages
resets the microcontroller.
VDD1
VDD2
VDD3
BD52□□□
NO.1
CT
BD52□□□
NO.2
CT
RL
RST
microcontroller
Fig.20
GND
When there are many power supplies of the system, power supplies VDD1 and VDD2 are being monitored separately, and it is
necessary to reset the microcomputer, it is possible to use an OR connection on the open drain output type BD52□□G/FVE
series to pull-up to the desired voltage (VDD3) as shown in Fig.17 and make the output “High” voltage matches the power
supply voltage VDD3 of the microcontroller.
www.rohm.com
© 2009 ROHM Co., Ltd. All rights reserved.
6/9
2009.06 - Rev.B
Share Link: 