ATA6621(2006_01) 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

일치하는 목록

ATA6621
(Rev.:2006_01)

LIN Transceiver with 5V Regulator and Watchdog

Atmel Corporation 

3.12 Modes of Operation

Figure 3-1. Modes of Operation

Unpowered Mode, VBat = 0V

b

a

b

b

Pre Normal Mode

VCC: 5V/50 mA with undervoltage reset

Communication: OFF

b

c+d

EN = 1

Normal Mode

VCC: 5V ±2%/50 mA

with undervoltage

reset

Communication: On

EN = 0

TXD = 1

EN = 0

EN = 0

TXD = 0

EN = 1

Go to silent command

Local wake-up event

Go to sleep command

Local wake-up event

c+d

Normal Mode

VCC: 5V ±7%/50 mA

with undervoltage reset

Communication: OFF

Sleep Mode

VCC: switched off

Communication: Off

a: VS > 5V

b: VS < 4V

c: Bus wake-up event

d: Wake-up from wake-up switch

3.12.1

Normal Mode

This is the normal transmitting and receiving mode. The voltage regulator is in normal mode and

can source 50 mA. The undervoltage detection is activated. The watchdog needs a trigger signal

from PTRIG or NTRIG to avoid resets at NRES.

3.12.2

Silent Mode

A falling edge at EN while TXD is high switches the IC into Silent Mode. The TXD signal has to

be logic high during the Mode Select window (Figure 3-2 on page 7). For EN and TXD either two

independent outputs can be used, or two outputs from the same microcontroller port; in the sec-

ond case, the mode change is only one command. In Silent Mode, the transmission path is

disabled. Supply current from VBat is typically IVSsi = 40 µA with no load at the VCC regulator.

The overall supply current from VBat is the addition of 40 µA plus the VCC regulator output current

IVCCs.

6 ATA6621

4887B–AUTO–01/06

Share Link: