AT27C512R-55TI 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

일치하는 목록

AT27C512R-55TI

512K 64K x 8 OTP CMOS EPROM

Atmel Corporation 

Description (Continued)

The AT27C512R is available in a choice of industry stand-

ard JEDEC-approved one-time programmable (OTP)

plastic PDIP, PLCC, SOIC, and TSOP packages. All de-

vices feature two-line control (CE, OE) to give designers

the flexibility to prevent bus contention.

With 64K byte storage capability, the AT27C512R allows

firmware to be stored reliably and to be accessed by the

system without the delays of mass storage media.

Atmel’s 27C512R has additional features to ensure high

quality and efficient production use. The Rapid™ Program-

ming Algorithm reduces the time required to program the

part and guarantees reliable programming. Programming

time is typically only 100 µs/byte. The Integrated Product

Identification Code electronically identifies the device and

manufacturer. This feature is used by industry standard

programming equipment to select the proper program-

ming algorithms and voltages.

System Considerations

Switching between active and standby conditions via the

Chip Enable pin may produce transient voltage excur-

sions. Unless accommodated by the system design, these

transients may exceed data sheet limits, resulting in de-

vice non-conformance. At a minimum, a 0.1 µF high fre-

quency, low inherent inductance, ceramic capacitor

should be utilized for each device. This capacitor should

be connected between the VCC and Ground terminals of

the device, as close to the device as possible. Additionally,

to stabilize the supply voltage level on printed circuit

boards with large EPROM arrays, a 4.7 µF bulk electrolytic

capacitor should be utilized, again connected between the

VCC and Ground terminals. This capacitor should be posi-

tioned as close as possible to the point where the power

supply is connected to the array.

3-136

AT27C512R

Share Link: