AT25080AN-10SE-2.7 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

일치하는 목록

AT25080AN-10SE-2.7

SPI Serial Extended Temperature EEPROMs

Atmel Corporation 

Functional

Description

5082B–SEEPR–1/05

AT25080A/160A/320A/640A

The AT25080A/160A/320A/640A is designed to interface directly with the synchronous

serial peripheral interface (SPI) of the 6805 and 68HC11 series of microcontrollers.

The AT25080A/160A/320A/640A utilizes an 8-bit instruction register. The list of instruc-

tions and their operation codes are contained in Table 5. All instructions, addresses, and

data are transferred with the MSB first and start with a high-to-low CS transition.

Table 5. Instruction Set for the AT25080A/160A/320A/640A

Instruction Name Instruction Format Operation

WREN

0000 X110

Set Write Enable Latch

WRDI

0000 X100

Reset Write Enable Latch

RDSR

0000 X101

Read Status Register

WRSR

0000 X001

Write Status Register

READ

0000 X011

Read Data from Memory Array

WRITE

0000 X010

Write Data to Memory Array

WRITE ENABLE (WREN): The device will power up in the write disable state when VCC

is applied. All programming instructions must therefore be preceded by a Write Enable

instruction.

WRITE DISABLE (WRDI): To protect the device against inadvertent writes, the Write

Disable instruction disables all programming modes. The WRDI instruction is indepen-

dent of the status of the WP pin.

READ STATUS REGISTER (RDSR): The Read Status Register instruction provides

access to the status register. The READY/BUSY and Write Enable status of the device

can be determined by the RDSR instruction. Similarly, the block write protection bits

indicate the extent of protection employed. These bits are set by using the WRSR

instruction.

Table 6. Status Register Format

Bit 7

Bit 6

Bit 5

Bit 4

WPEN

X

X

X

Bit 3

BP1

Bit 2

BP0

Bit 1

WEN

Bit 0

RDY

Table 7. Read Status Register Bit Definition

Bit

Definition

Bit 0 (RDY)

Bit 0 = “0” (RDY) indicates the device is ready. Bit 0 = “1” indicates the write

cycle is in progress.

Bit 1 (WEN)

Bit 1= “0” indicates the device is not write-enabled. Bit 1 = “1” indicates the

device is write-enabled.

Bit 2 (BP0)

See Table 8 on page 8.

Bit 3 (BP1)

See Table 8 on page 8.

Bits 4 − 6 are “0”s when device is not in an internal write cycle.

Bit 7 (WPEN) See Table 9 on page 8.

Bits 0 − 7 are “1”s during an internal write cycle.

7

Share Link: