GRM188R61E105KA12D 데이터 시트보기 (PDF) - Alpha and Omega Semiconductor
부품명
상세내역
일치하는 목록
GRM188R61E105KA12D
Alpha and Omega Semiconductor
GRM188R61E105KA12D Datasheet PDF : 4 Pages
| |||
AOZ1019-EVA
Quick Start Guide
1. Connect the terminals of load to +VOUT pins and GND pins. Set load current to between 0A and 2A.
2. Connect the DC power supply to +VIN pin and GND pins. Set DC power supply voltage to between 4.5V and 16V.
3. Connect EN pin to +VIN or any voltage source which is higher than 2V and less than 16V.
4. Turn on DC power supply and evaluation circuit will start.
5. Measure input voltage at the +VIN pin and GND pins to eliminate the effect of voltage drop on wire between DC
power supply and evaluation board.
6. Measure output voltage at the +VOUT pin and GND pins to eliminate the effect of voltage drop on wire between load
and evaluation board.
7. Use an oscilloscope to monitor input ripple voltage right across input capacitor C1.
8. Use an oscilloscope to monitor output ripple voltage right across output capacitor C2.
This datasheet contains preliminary data; supplementary data may be published at a later date.
Alpha & Omega Semiconductor reserves the right to make changes at any time without notice.
LIFE SUPPORT POLICY
ALPHA & OMEGA SEMICONDUCTOR PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL
COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS.
As used herein:
1. Life support devices or systems are devices or
systems which, (a) are intended for surgical implant into
the body or (b) support or sustain life, and (c) whose
failure to perform when properly used in accordance
with instructions for use provided in the labeling, can be
reasonably expected to result in a significant injury of
the user.
2. A critical component in any component of a life
support, device, or system whose failure to perform can
be reasonably expected to cause the failure of the life
support device or system, or to affect its safety or
effectiveness.
Rev. 1.0 October 2007
www.aosmd.com
Page 4 of 4
Share Link: