datasheetbank_Logo
전자부품 반도체 검색엔진( 무료 PDF 다운로드 ) - 데이터시트뱅크

ADXL335(2008) 데이터 시트보기 (PDF) - Analog Devices

부품명
상세내역
일치하는 목록
ADXL335
(Rev.:2008)
ADI
Analog Devices ADI
ADXL335 Datasheet PDF : 11 Pages
1 2 3 4 5 6 7 8 9 10
ADXL335
Preliminary Technical Data
The ADXL335 output is ratiometric, therefore, the output
sensitivity (or scale factor) varies proportionally to the
supply voltage. At VS = 3.6 V, the output sensitivity is
typically 360 mV/g. At VS = 2 V, the output sensitivity is
typically 195 mV/g.
The zero g bias output is also ratiometric, so the zero g output is
nominally equal to VS/2 at all supply voltages.
The output noise is not ratiometric but is absolute in volts;
therefore, the noise density decreases as the supply voltage
increases. This is because the scale factor (mV/g) increases
while the noise voltage remains constant. At VS = 3.6 V, the
X- and Y-axis noise density is typically 120 μg/√Hz, while at
VS = 2 V, the X- and Y-axis noise density is typically 270 μg/√Hz.
Self test response in g is roughly proportional to the square of
the supply voltage. However, when ratiometricity of sensitivity
is factored in with supply voltage, the self test response in volts
is roughly proportional to the cube of the supply voltage. For
example, at VS = 3.6 V, the self test response for the ADXL335 is
approximately −275 mV for the X-axis, +275 mV for the Y-axis,
and −100 mV for the Z-axis.
XOUT = –1g
YOUT = 0g
ZOUT = 0g
At VS = 2 V, the self test response is approximately −60 mV for
the X-axis, +60 mV for the Y-axis, and −25 mV for the Z-axis.
The supply current decreases as the supply voltage decreases.
Typical current consumption at VS = 3.6 V is 375 μA, and
typical current consumption at VS = 2 V is 200 μA.
AXES OF ACCELERATION SENSITIVITY
AZ
AY
TOP
AX
Figure 5. Axes of Acceleration Sensitivity, Corresponding Output Voltage
Increases When Accelerated Along the Sensitive Axis
XOUT = 0g
YOUT = 1g
ZOUT = 0g
TOP
TOP
TOP
XOUT = 0g
YOUT = –1g
ZOUT = 0g
GRAVITY
TOP
XOUT = 1g
YOUT = 0g
ZOUT = 0g
TOP
XOUT = 0g
YOUT = 0g
ZOUT = 1g
Figure 6. Output Response vs. Orientation to Gravity
XOUT = 0g
YOUT = 0g
ZOUT = –1g
Rev. PrA | Page 8 of 11

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]