AD9895 데이터 시트보기 (PDF) - Analog Devices

부품명

상세내역

일치하는 목록

AD9895

CCD Signal Processors with Precision Timing™ Generator

Analog Devices 

AD9891/AD9895

SYSTEM OVERVIEW

Figure 5 shows the typical system block diagram for the AD9891/

AD9895 used in Master Mode. The CCD output is processed by

the AD9891/AD9895’s AFE circuitry, which consists of a CDS,

PxGA, VGA, black level clamp, and an A/D converter. The digi-

tized pixel information is sent to the digital image processor chip,

which performs the post-processing and compression. To operate

the CCD, all CCD timing parameters are programmed into the

AD9891/AD9895 from the system microprocessor, through the

3-wire serial interface. From the system master clock, CLI, pro-

vided by the image processor or external crystal, the AD9891/

AD9895 generates all of the CCD’s horizontal and vertical clocks

and all internal AFE clocks. External synchronization is provided

by a SYNC pulse from the microprocessor, which will reset

internal counters and resync the VD and HD outputs.

V-DRIVER

V1–V4, VSG1–VSG8, SUBCK

CCD

H1–H4, RG, VSUB

CCDIN

MSHUT

STROBE

AD989x

DOUT

DCLK

CLPOB/PBLK

LD/FD

HD, VD

CLI

SERIAL

INTERFACE

SYNC

␮P

DIGITAL

IMAGE

PROCESSING

ASIC

Figure 5. Typical System Block Diagram, Master Mode

Alternatively, the AD9891/AD9895 may be operated in Slave

Mode, in which the VD and HD are provided externally from

the image processor. In this mode, all AD9891/AD9895 timing

will be synchronized with VD and HD.

The H-drivers for H1–H4 and RG are included in the AD9891/

AD9895, allowing these clocks to be directly connected to the CCD.

H-drive voltage of up to 5 V is supported. An external V-driver is

required for the vertical transfer clocks, the sensor gate pulses,

and the substrate clock.

The AD9891/AD9895 also includes programmable MSHUT

and STROBE outputs, which may be used to trigger mechani-

cal shutter and strobe (flash) circuitry.

Figure 6 shows the horizontal and vertical counter dimensions

for the AD9891/AD9895. All internal horizontal and vertical

clocking is programmed using these dimensions to specify line

and pixel locations.

MAXIMUM

FIELD

DIMENSIONS

12-BIT HORIZONTAL = 4096 PIXELS MAX

12-BIT VERTICAL = 4096 LINES MAX

Figure 6. Vertical and Horizontal Counters

REV. A

–11–

Share Link: