AD1987(Rev0) 데이터 시트보기 (PDF) - Analog Devices
부품명
상세내역
일치하는 목록
AD1987 Datasheet PDF : 18 Pages
| |||
AD1987
Table 5. AD1987 Pin Descriptions
Mnemonic
Pin No. Function
Description
DIGITAL INTERFACE
SDATA_OUT
5
I
Link Serial Data Output. Clocked on both edges of BIT_CLK.
BIT_CLK
6
I
Link Bit Clock. 24.000 MHz serial data clock.
SDATA_IN
8
I/O
Link Serial Data Input. AD1987 output stream clocked only on one edge of BIT_CLK.
SYNC
10
I
Link Frame Sync.
RESET
11
I
Link Reset. Master hardware reset.
DIGITAL I/O
GPIO_0
2
I/O
General Purpose Input/Output Pin. Digital signal used to control external circuitry.
GPIO_1/EAPD
47
I/O
General Purpose Input/Output Pin/EAPD Pin. Digital signal used to control external
circuitry. By default pin is in a Hi-Z state. When used as EAPD: Hi-Z = amp-on,
S/PDIF_OUT
48
O
DVSS = amp off.
S/PDIF_OUT. Supports S/PDIF output.
JACK SENSE
SENSE_A/SRC_B
13
I/O
JACK Sense A-D Input/Sense B drive.
SENSE_B/SRC_A
34
I/O
JACK Sense E-H Input/Sense A drive.
ANALOG I/O
PCBEEP
2
LI
Monaural Input From System for Analog PCBeep.
Port E_L
14
LI, MIC, LO, SWAP Auxiliary Input/Output Left Channel.
Port E_R
15
LI, MIC, LO, SWAP Auxiliary Input/Output Right Channel.
Port F_L
16
LO
Auxiliary Input/Output Left Channel.
Port F_R
17
LO
Auxiliary Input/Output Right Channel.
CD_L
18
LI
CD Audio Left Channel.
CD_GND
19
LI
CD-Audio-Analog-Ground-Reference (for Differential CD Input). Must be connected
to AGND via 0.1 μF capacitor if not in use as CD_GND.
CD_R
20
LI
CD Audio Right Channel.
Port B_L
21
LI, MIC, HP, LO Front Panel Stereo MIC/Line-In.
Port B_R
22
LI, MIC, HP, LO Front Panel Stereo MIC/Line-In.
Port C_L
23
LI, MIC, LO
Rear Panel Stereo MIC/Line-In.
Port C_R
24
LI, MIC, LO
Rear Panel Stereo MIC/Line-In.
Port D_L
35
LI, HP, LO
Rear Panel Headphone/Line-Out.
Port D_R
36
LI, HP, LO
Rear Panel Headphone/Line-Out.
Port A_L
39
LI, MIC, HP, LO Front Panel Headphone/Line-Out.
MONO_OUT
40
LO
Monaural Output to Internal Speaker or Telephony Subsystem Speakerphone.
Port A_R
41
LI, MIC, HP, LO Front Panel Headphone/Line-Out.
Port G_L
43
LO, SWAP
Rear Panel C/LFE Output.
Port G_R
44
LO, SWAP
Rear Panel C/LFE Output.
Port H_L
45
LO
Rear Panel Surround Center/Side.
Port H_R
46
LO
Rear Panel Surround Center/Side.
FILTER/REFERENCE
MIC_BIAS-B
28
O
Switchable Microphone Bias. For use with Port B (Pins 21, 22).
MIC_BIAS-C
29
O
Switchable Microphone Bias. For use with Port C (Pins 23, 24).
MIC_BIAS-E
31
O
Switchable Microphone Bias. For use with Port E (Pins 14, 15).
VREF_FILT
MIC_BIAS-A
33
O
37
O
Voltage Reference Filter.
Switchable Microphone Bias. For use with Port A (Pins 39, 41)
All MIC_BIAS pins are capable of:
Hi-Z, 0 V, 1.65 V, 3.78 V, and 3.95 V (with 5.0 V on Pin 33)
DVCORE
1
O
Hi-Z, 0 V, 1.65 V, 2.86 V, and 3.00 V (with 3.3 V on Pin 33).
CAUTION: DO NOT APPLY 3.3 V TO THIS PIN!
Filter connection for internal core voltage regulator.
This pin must be connected to filter caps: 10 μF, 1.0 μF and 0.1 μF connected in
parallel between Pin 1 and DVSS (Pin 4).
The symbols used in this table are defined as: I = Input, O = Output, LI = Line level input, LO = Line level output, HP = Output capable of driving
headphone load, MIC = Input supports microphones with MIC bias and boost amplifier, SWAP = Outputs can swap L/R channels (typically used
to support C/LFE or shared C/LFE function).
Rev. 0 | Page 10 of 18 | May 2007
Share Link: 