TC3404VPE 데이터 시트보기 (PDF) - Microchip Technology

부품명

상세내역

일치하는 목록

TC3404VPE

+1.8V Low Power, Quad Input, 16-Bit Sigma-Delta A/D Converter with a Power Fault Monitor

Microchip Technology 

TC3404

3.3 Power Fail Detector

The Power Fail detector is a comparator in which the

inverting input is connected to the internal voltage

reference. The non-inverting input is the PFI pin of the

TC3404 and the PFO pin is the active low, open drain

output. This comparator is suitable as an early warning

fail or low battery indicator. In a typical application,

where a voltage regulator is being used to supply

power to a system, the Power Fail comparator would

monitor the input voltage to the regulator while the VDD

monitor would measure the output voltage of the

regulator. Both PFO and RESET would drive interrupt

pins of a microcontroller.

The Power Fail detector may be used as a Wake-up or

Watchdog Timer. The Typical Application circuit shows

an RC network on PFI with the capacitor tied to a

tristated μC I/O pin. If R4 is 1 MΩ and C2 is 10μF, the

time constant is roughly ten seconds. The μC resets

the RC network by driving the I/O tied to PFI low and

then tristating it. The RC network will ramp to 1.23V in

roughly 9 seconds, assuming a VBATT of 3.0V. With

PFO tied to a μC input or interrupt, the μC will see a low

to high transition on PFO when the voltage on PFI

exceeds 1.23V. The PFO output is specified to be valid

for VDD = 1.3 to 5.5V.

DS21413C-page 10

© 2005 Microchip Technology Inc.

Share Link: