2N5010 데이터 시트보기 (PDF) - Microsemi Corporation
부품명
상세내역
일치하는 목록
2N5010 Datasheet PDF : 4 Pages
| |||
6 Lake Street, Lawrence, MA 01841
1-800-446-1158 / (978) 620-2600 / Fax: (978) 689-0803
Website: http: //www.microsemi.com
TECHNICAL DATA SHEET
PACKAGE DIMENSIONS
Symbol
CD
CH
HD
LC
LD
LL
LU
L1
L2
P
Q
TL
TW
r
α
Dimensions
Inches
Min Max
Millimeters
Min Max
.305 .335 7.75 8.51
.240 .260 6.10 6.60
.335 .370
.200 TP
8.51 9.40
5.08 TP
.016 .019 0.41 0.48
See note 14
.016 .019 0.41 0.48
.050
1.27
.250
6.35
.100
2.54
.030
0.76
.029 .045 0.74 1.14
.028 .034 0.71 0.86
.010
0.25
45° TP
45° TP
1, 2, 10, 12, 13, 14
Notes
6
7
8,9
8,9
8,9
8,9
7
5
3,4
3
10
7
NOTE:
1. Dimensions are in inches.
2. Millimeters are given for general information only.
3. Beyond r (radius) maximum, TW shall be held for a minimum length of .011 (0.28 mm).
4. Dimension TL measured from maximum HD.
5. Body contour optional within zone defined by HD, CD, and Q.
6. CD shall not vary more than .010 inch (0.25 mm) in zone P. This zone is controlled for automatic handling.
7. Leads at gauge plane .054 +.001 -.000 inch (1.37 +0.03 -0.00 mm) below seating plane shall be within .007 inch (0.18 mm)
radius of true position (TP) at maximum material condition (MMC) relative to tab at MMC. The device may be measured
by direct methods or by gauging procedure.
8. Dimension LU applies between L1 and L2. Dimension LD applies between L2 and LL minimum. Diameter is uncontrolled
in and beyond LL minimum.
9. All three leads.
10. The collector shall be internally connected to the case.
11. Dimension r (radius) applies to both inside corners of tab.
12. In accordance with ASME Y14.5M, diameters are equivalent to Φx symbology.
13. Lead 1 = emitter, lead 2 = base, lead 3 = collector.
14. For non-S-suffix devices (TO-5), dimension LL = 1.5 inches (38.10 mm) min. and 1.75 inches (44.45 mm) max. For S-
suffix types (TO-39), dimension LL = .5 inch (12.70 mm) min. and .750 inch (19.05 mm) max.
T4-LDS-0067 Rev. 2 (100293)
Page 4 of 4
Share Link: 