AK4356 데이터 시트보기 (PDF) - Asahi Kasei Microdevices

부품명

상세내역

일치하는 목록

AK4356

192kHz 24Bit Six-Channel DAC for DVD-Audio

Asahi Kasei Microdevices 

ASAHI KASEI

[AK4356]

n Power-down

All DACs are placed in the power-down mode by bringing PDN pin “L” and each digital filter is also reset at the same time.

The internal register values are initialized by PDN “L”. This reset should always be done after power-up. Because some

click noise occurs at the edge of PDN, the analog output should be muted externally if the click noise influences system

application. Figure 6 shows the power-down/up sequence.

Each DAC can be powered down by each power-down bit (PW1-3) “0”. In this case, the internal register values are not

initialized and the analog output is Hi-Z. Because some click noise occurs, the analog output should be muted externally if

the click noise influences system application.

If DAC1 is in 4 times speed mode (DFS1=1, DFS0=0), DAC2 and DAC3 are automatically powered down. Both analog

outputs go to analog common voltage (AVDD/2).

PDN

Internal

State

D/A In

(Digital)

D/A Out

(Analog)

Clock In

MCLK, LRCK, BICK

Normal Operation

Power-down

“0” data

GD (1)

(3) (2)

(4)

Don’t care

Normal Operation

GD (1)

(3)

DZF

(6)

External

MUTE

(5)

Mute ON

Notes:

(1) The analog output corresponding to digital input has the group delay (GD).

(2) Analog outputs are floating (Hi -Z) at the power-down mode.

(3) Click noise occurs at the edge of PDN signal. This noise is output even if “0” data is input.

(4) The external clocks (MCLK, BICK and LRCK) can be stopped in the power-down mode (PDN = “L”).

(5) Please mute the analog output externally if the click noise (3) influences system application.

The timing example is shown in this figure.

(6) DZF pins of all channels are “L” in the power-down mode (PDN = “L”).

Figure 6. Power-down/up sequence example

M0072-E-01

- 18 -

1999/09

Share Link: