TGF4118-EPU 데이터 시트보기 (PDF) - TriQuint Semiconductor
부품명
상세내역
일치하는 목록
TGF4118-EPU Datasheet PDF : 9 Pages
| |||
Application circuit for the TGF4118-EPU at 2.3 GHz
The FET is soldered using AuSn solder at 300 C for 30 secs. Input and Output matching networks are
0.381 mm ZrSn Tioxide substrates (Er = 38). The design load impedance is between 4 Ω and 5 Ω with
the 6 pF output capacitance of the FETincluded in the output network. For further explanation refer to
the application note “Designing High Efficiency Amplifiers using HFETs”. The carrier plate is 0.51 mm
gold plated copper molybdenum. Gold wire (0.018 mm) is used for the bonds. Four gate bonds are
required with a length of 0.42 mm. Eight drain bonds are required with a length of 0.42 mm. Bondwire
end points on the FET are in the middle of the bond pads. Refer to the figures above for bondwire
locations. Connection between the 50 ohm line input to the input match is made by a parallel RC
network. R1 in this network is 10 ohms, and C1 is 5.6 pF. The components used are surface mount
0603 piece parts.
TriQuint Semiconductor Texas Phone: 972 994-8465 Fax 972 994-8504
Web: www.triquint.com 9
Share Link: 