M61311SP 데이터 시트보기 (PDF) - MITSUBISHI ELECTRIC

부품명

상세내역

일치하는 목록

M61311SP

I2C BUS CONTROLLED VIDEO PRE-AMP FOR HIGH RESOLUTION COLOR DISPLAY

MITSUBISHI ELECTRIC  

MITSUBISHI ICs (MONITOR)

M61311SP/M61316SP

I2C BUS CONTROLLED VIDEO PRE-AMP FOR HIGH RESOLUTION COLOR DISPLAY

Note1) Measuring conditions are as listed in supplementary Table. Measured with a current meter at test point IB.

Note2) Measuring conditions are as listed in supplementary Table. Measured with a current meter at test point IA.

Note3) Measuring conditions are as listed in supplementary Table. Measured with a current meter at test point IB.

Note4) It makes the amplitude of SG1 1.4p-p. Measure the DC voltage of the white level of the waveform output.

The measured value is called Vomax.

(VDC)

Vomax

Waveform output

0.5

0.0

Note5) Increase the input signal(SG1) amplitude gradually, starting from 0.7Vp-p. Measure the amplitude of the

input signal when the output signal starts becoming distorted.

Note6) Input SG1, and measure the amplitude output at OUT(26,28,30). The amplitude is called VOUT(26,28,30).

Maximum gain GV is calculated by the equation below:

GV = 20 LOG ( VOUT / 0.7 ) (dB)

Note7) Relative maximum gain GV is calculated by the equation below:

GV = VOUT(26) / VOUT(28) , VOUT(28) / VOUT(30) , VOUT(30) / VOUT(26)

Note8) Input SG1, and measure the amplitude output at OUT(26,28,30). The amplitude is called VOUT(26,28,30).

The measured value is called VC1.

Note9) Relative characteristics VC1 is calculated by the equation below:

VC1 = VOUT(26) / VOUT(28) , VOUT(28) / VOUT(30) , VOUT(30) / VOUT(26)

Note10) Measuring condition and procedure are the same as described in Note8.

Note11) Measuring condition and procedure are the same as described in Note9.

Note12) Measuring condition and procedure are the same as described in Note8.

Note13) Relative characteristics VC3 is calculated by the equation below:

VC3 = VOUT(26) - VOUT(28) , VOUT(28) - VOUT(30) , VOUT(30) - VOUT(26)

NOte14) Input SG1, and measure the amplitude output at OUT(26,28,30). The amplitude is called VOUT(26,28,30).

The measured value is called VSC1.

Note15) Relative characteristics VSC1 is calculated by the equation below:

VSC1 = VOUT(26) / VOUT(28) , VOUT(28) / VOUT(30) , VOUT(30) / VOUT(26)

Note16) Measuring condition and procedure are the same as described in Note14.

Note17) Measuring condition and procedure are the same as described in Note15.

Note18) Measuring condition and procedure are the same as described in Note14.

Note19) Relative characteristics VSC3 is calculated by the equation below:

VSC3 = VOUT(26) - VOUT(28) , VOUT(28) - VOUT(30) , VOUT(30) - VOUT(26)

MITSUBISHI

ELECTRIC

8

Share Link: