SPX3940T-2.5 데이터 시트보기 (PDF) - Signal Processing Technologies

부품명

상세내역

일치하는 목록

SPX3940T-2.5

1A Low Dropout Voltage Regulator Fixed Output, Fast Response

Signal Processing Technologies 

The SPX3940 incorporates protection against

over-current faults, reversed load insertion, over

temperature operation, and positive and nega-

tive transient voltage.

Thermal Considerations

Although the SPX3940 offers limiting circuitry

for overload conditions, it is still necessary to

insure that the maximum junction temperature

is not exceeded in the application. Heat will

flow through the lowest resistance path, the

junction-to-case path. In order to insure the best

thermal flow of the component, proper mount-

ing is required. Consult heatsink manufacturer

for thermal resistance and design of heatsink.

APPLICATION INFORMATION

For example, TO-220 design:

Assume that V = 10V, V = 5V, I = 1.5A,

IN

OUT

OUT

T

A

=

50°C/W,

θHA=

1°C/W,

θCH

=

2°C/W,

and

θJC = 3°C/W.

Where TA = ambient temperature

θHA = heatsink to ambient thermal resistance

θCH = case to heatsink thermal resistance

θJC = junction to case thermal resistance

The power calculated under these conditions is:

PD = (VIN - VOUT) * IOUT = 7.5W.

And the junction temperature is calculated as

TJ = TA + PD * (θHA + θCH + θJC) or

T

J

=

50

+

7.5

*

(1

+

2

+

3)

=

95°C

Reliable operation is insured.

VIN

6.8µF+

1 SPX3940 3

2

VOUT

+10µF

Figure 18. Fixed Output Linear Regulator.

Capacitor Requirements

The output capacitor is needed to insure stability and minimize the output noise. The value of the

capacitor varies with the load. However, a minimum value of 10µF aluminum capacitor will guarantee

stability over all load conditions. A tantalum capacitor is recommended if a faster load transient

response is needed.

If the power source has a high AC impedance, a 0.1µF ceramic capacitor between input & ground is

recommended.

Minimum Load Current

To ensure a proper behavior of the regulator under light load, a minimum load of 5mA for SPX3940

is required.

Date: 5/25/04

SPX3940 1A Low Dropout Voltage Regulator

6

© Copyright 2004 Sipex Corporation

Share Link: