MD54-0007
Low Cost MMIC Mixer
2.1 - 2.7 GHz
Electrical Specifications: TA = 25°C, ZO = 50 Ω 3,4, RF Frequency: 2.1 - 2.7 GHz
Parameter
Test Conditions
Units
Min
Typ
Conversion Loss
Isolation
VSWR
P1dB
Two-Tone IMR
—
LO to RF
LO to IF
RF to IF
RF Port
LO Port
IF Port
—
Two Tones at 0 dBm each, Tone spacing = 300 KHz,
IF = 150 MHz
dB
dB
dB
dB
Ratio
Ratio
Ratio
dBm
dBc
—
8.0
15
25
—
18
—
18
—
2.0:1
—
2.0:1
—
2.0:1
—
18
45
50
3. RF signal is 2428 MHz at 0 dB, LO signal is 2278 MHz at +13 dBm and IF signal is 150 MHz unless otherwise specified.
4. With external LO port matching. See functional schematic.
Rev. V4
Max
9.0
—
—
—
—
—
—
—
—
Absolute Maximum Ratings 5
Parameter
Absolute Maximum
RF Input Power 6
+27 dBm
LO Drive Power 6
+27 dBm
Operating Temperature
-40°C to +85°C
Storage Temperature
-40°C to +150°C
Channel Temperature
+150°C
5. Exceeding any one or combination of these limits may cause
permanent damage to this device.
6. Ambient Temperature (TA) = +25°C
SOT-25
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
Gallium Arsenide Integrated Circuits are sensitive
to electrostatic discharge (ESD) and can be
damaged by static electricity. Proper ESD control
techniques should be used when handling these
devices.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: +91.80.43537383
• China Tel: +86.21.2407.1588
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.