MAX7470 데이터 시트보기 (PDF) - Maxim Integrated

부품명

상세내역

일치하는 목록

MAX7470

HDTV Continuously Variable Anti-Aliasing Filters

Maxim Integrated 

HDTV Continuously Variable

Anti-Aliasing Filters

START and STOP Conditions

A master device initiates communication by issuing a

START condition, a high-to-low transition on SDA with SCL

high (Figure 2). The master terminates transmission by a

STOP condition (see the Acknowledge Bit (ACK) and Not-

Acknowledge Bit (NACK) section). A STOP condition is a

low-to-high transition on SDA while SCL is high (Figure 2).

The STOP condition frees the bus. If a repeated START

condition is generated instead of a STOP condition, the

bus remains active. When a STOP condition or incorrect

address is detected, the MAX7469/MAX7470 then ignore

all communication on the I2C bus until the next START or

REPEATED START condition, minimizing digital noise

and feedthrough.

Early STOP Conditions

The MAX7469/MAX7470 recognize a STOP condition at

any point during transmission except when a STOP

condition occurs in the same high pulse as a START

condition (Figure 3). This condition is not a legal I2C for-

mat; at least one clock pulse must separate any START

and STOP conditions. The MAX7469/MAX7470 discard

any data received during a data transfer aborted by an

early STOP condition.

Repeated START (Sr) Conditions

An Sr condition is used to indicate a change in direc-

tion of data flow (see the Read Cycle section). Sr can

also be used when the bus master is writing to several

I2C devices and does not want to relinquish control of

the bus. The MAX7469/MAX7470 serial interface sup-

ports continuous write operations with (or without) an Sr

condition separating them.

S

SCL

Sr

P

SDA

Figure 2. START/STOP Conditions

LEGAL STOP CONDITION

SCL

SCL

SDA

SDA

STOP

START

Figure 3. Early STOP Conditions

ILLEGAL STOP CONDITION

START

ILLEGAL STOP

10 _______________________________________________________________________________________

Share Link: