050-611-5607899 데이터 시트보기 (PDF) - ITT Cannon

부품명

상세내역

일치하는 목록

050-611-5607899

RF Coaxial Connectors

ITT Cannon  

RF Coaxial Connectors

Assembly Instructions

AI-762 & AI-763 CMM Straight Connectors, Direct Solder Type for Semi-Rigid Cable

BODY CABLE ENTRY

PLUG

JACK

1. Trim cable to dimension ‘B’ shown. Being careful not to nick the center conductor.

Cable Dia. A

1,20 (.047)

B

2,04 (.080)

2. Place two solder rings per table below, over the cable.

Cable Dia.

1,20 (.047)

‘C’ Dia. max Solder Wire Dia.

1,78 (.070)

0,26 (.010)

3. Place connector in fixture base seated against locator and insert cable into cable entry end of

connector until cable seats firmly. Tighten Clamp screw to secure cable. Tighten locator tool firmly

against connector interface (plug) or front of connector (jack). Slide solder rings against rear body

as shown. Apply sufficient heat to rear body only using an appropriate heat source (solder tongs Assy Insts

with variable control) for solder to flow but using minimum heat cycle.

Dimensions are shown in mm (inch)

Dimensions subject to change 127

Share Link: