EVAL-AD7687SDZ(RevC) 데이터 시트보기 (PDF) - Analog Devices
부품명
상세내역
일치하는 목록
EVAL-AD7687SDZ
(Rev.:RevC)
(Rev.:RevC)
Analog Devices
EVAL-AD7687SDZ Datasheet PDF : 28 Pages
| |||
AD7687
PIN CONFIGURATIONS AND FUNCTION DESCRIPTIONS
Data Sheet
REF 1
VDD 2
IN+ 3
IN– 4
GND 5
10 VIO
AD7687
TOP VIEW
(Not to Scale)
9 SDI
8 SCK
7 SDO
6 CNV
Figure 5. 10-Lead MSOP Pin Configuration
REF 1
VDD 2
IN+ 3
IN– 4
GND 5
AD7687
TOP VIEW
(Not to Scale)
10 VIO
9 SDI
8 SCK
7 SDO
6 CNV
NOTES
1. FOR THE LFCSP PACKAGE ONLY,
THE EXPOSED PADDLE MUST BE
CONNECTED TO GND.
Figure 6. 10-Lead LFCSP Pin Configuration
Table 8. Pin Function Descriptions
Pin No. Mnemonic Type1 Function
1
REF
AI
Reference Input Voltage. The REF range is from 0.5 V to VDD. It is referred to the GND pin. This pin should
be decoupled closely to the pin with a 10 µF capacitor.
2
VDD
P
Power Supply.
3
IN+
AI
Differential Positive Analog Input.
4
IN−
AI
Differential Negative Analog Input.
5
GND
P
Power Supply Ground.
6
CNV
DI
Convert Input. This input has multiple functions. On its leading edge, it initiates the conversions and
selects the interface mode, chain or CS. In CS mode, it enables the SDO pin when low. In chain mode, the
data should be read when CNV is high.
7
SDO
DO Serial Data Output. The conversion result is output on this pin. It is synchronized to SCK.
8
SCK
DI
Serial Data Clock Input. When the part is selected, the conversion result is shifted out by this clock.
9
SDI
DI
Serial Data Input. This input provides multiple features. It selects the interface mode of the ADC as follows:
Chain mode is selected if SDI is low during the CNV rising edge. In this mode, SDI is used as a data input to
daisy chain the conversion results of two or more ADCs onto a single SDO line. The digital data level on SDI
is output on SDO with a delay of 16 SCK cycles.
CS mode is selected if SDI is high during the CNV rising edge. In this mode, either SDI or CNV can enable
the serial output signals when low, and if SDI or CNV is low when the conversion is complete, the BUSY
indicator feature is enabled.
10
VIO
P
Input/Output Interface Digital Power. Nominally at the same supply as the host interface (1.8 V, 2.5 V, 3 V,
or 5 V).
EPAD
N/A For the LFCSP package only, the exposed paddle must be connected to GND.
1AI = Analog Input, DI = Digital Input, DO = Digital Output, P = Power, and N/A = not applicable.
Rev. C | Page 8 of 28
Share Link: