RF2469PCBA 데이터 시트보기 (PDF) - RF Micro Devices

부품명

상세내역

일치하는 목록

RF2469PCBA

W-CDMA AND PCS LOW NOISE AMPLIFIER/MIXER DOWNCONVERTER

RF Micro Devices 

RF2469

Preliminary

Output Interface Network of the Mixer

L1, C1, C2, and R form a current combiner which performs a differential to single-ended conversion at the IF frequency

and sets the output impedance. In most cases, the resonance frequency is independent of R and can be set according to

the following equation:

fIF

=

-----------------------------1------------------------------

2π

-L---1--

2

(C1

+

2C2

+ CEQ)

Where CEQ is the equivalent stray capacitance and capacitance looking into pins 9 and 10. An average value to use for

CEQ is 2.5 pF.

R can then be used to set the output impedance according to the following equation:

R

=

æ

è

----------1----------

4 ⋅ ROUT

–

R--1--P--øö –1

where ROUT is the desired output impedance and RP is the parasitic equivalent parallel resistance of L1.

C2 should first be set to 0 and C1 should be chosen as high as possible, while maintaining an RP of L1 that allows for the

desired ROUT. If the self-resonant frequencies of the selected C1 produce unsatisfactory linearity performance, their val-

8

ues may be reduced and compensated for by including C2 capacitor with a value chosen to maintain the desired FIF fre-

quency.

L2 and C3 serve dual purposes. L2 serves as an output bias choke, and C3 serves as a series DC block.

In addition, L2 and C3 may be chosen to form an impedance matching network if the input impedance of the IF filter is

not equal to ROUT. Otherwise, L2 is chosen to be large (suggested 120nH) and C3 is chosen to be large (suggested

22nF) if a DC path to ground is present in the IF filter, or omitted if the filter is DC-blocked.

8-40

Rev A5 010717

Share Link: