MAX1680C 데이터 시트보기 (PDF) - Maxim Integrated
부품명
상세내역
일치하는 목록
MAX1680C Datasheet PDF : 12 Pages
| |||
125mA, Frequency-Selectable,
Switched-Capacitor Voltage Converters
Table 4. Minimum Recommended Capacitances for Maximum Output Current
fOSC (kHz)
125
250
500
1000
VIN = 2V
2.5
1.2
0.6
0.3
CAPACITANCE (µF) (C1 = C2)
VIN = 3V
VIN = 4V
3.8
5.1
1.9
2.5
0.9
1.2
0.4
0.6
VIN = 5V
6.4
3.2
1.6
0.8
+VINPUT
1µF
FSEL
CAP+
IN
SHDN
MAX1681
1µF
GND
LV
CAP-
OUT
VOUT = -VINPUT
1µF
FSEL
IN
CAP+ SHDN
1µF
MAX1681
LV
GND
CAP-
OUT
VOUT = -2VINPUT
1µF
NOTE: USE 4.7µF CAPACITORS FOR MAX1680.
Figure 1. Cascading MAX1680/MAX1681s to Increase Output Voltage
Bypass Capacitor
Bypass the input voltage to reduce AC impedance and
to prevent internal switching noise. Bypassing depends
on the source impedance location. The AC ripple cur-
rent is 2 x IOUT for the doubler and the inverter. Use a
large bypass capacitor (equal to C1) if the supply has
high AC impedance.
Cascading Devices
To produce larger negative voltages, cascade two
devices (Figure 1). For two devices, the unloaded out-
put voltage is approximately -2 x VINPUT, but this value
is reduced slightly by the first device’s output resis-
tance multiplied by the second device’s quiescent cur-
rent. The effective output resistance for a cascaded
device is larger than that for an individual device (20Ω
for two devices). Cascading several devices increases
output resistance and reduces efficiency. If a large
negative voltage is required for several stages, an
inductive inverting switching regulator such as the
MAX629 or MAX774 may offer more advantages.
Paralleling Devices
Parallel two or more MAX1680/MAX1681s to reduce
output resistance voltage drop under a given load. With
reduced output resistance, paralleled devices deliver
higher load currents. Figure 2 shows two
MAX1680/MAX1681s connected in parallel. Output
resistance is inversely proportional to the number of
devices.
8 _______________________________________________________________________________________
Share Link: 