RTOP100(2004) 데이터 시트보기 (PDF) - Vishay Semiconductors
부품명
상세내역
일치하는 목록
RTOP100
(Rev.:2004)
(Rev.:2004)
Vishay Semiconductors
RTOP100 Datasheet PDF : 4 Pages
| |||
Power Resistors for Mounting onto a Heatsink
Thick Film Technology
RTOP
Vishay Sfernice
CHOICE OF HEATSINK
The user must choose the heatsink according to the working conditions of the component (power, room temperature).
Maximum working temperature must not exceed 125°C. The dissipated power is simply calculated by the following ratio:
P=
∆T
(1)
[RTH (j-c) + RTH (c-a)]
P: expressed in W
∆T: difference between maximum working temperature and room temperature.
RTH: (j-c): thermal resistance value measured between resistive layer and outer side of the resistor. It is the thermal
resistance of the component (see Table Special Features).
RTH: (c-a): thermal resistance value measured between outer side of the resistor and room temperature. It is the
thermal resistance of the heatsink depending on the heatsink itself (type, shape) and the quality of the fastening
device.
Example:
RTH: (c-a) for RTOP 200 power rating 130W at ambient temperature + 30°C.
Thermal resistance (see table 1) RTH (j-c): 0.5°C/W
∆T ≤ 125°C - 30°C - ≤ 95°C
RTH
(j-c)
+
RTH
(c-a)
=
∆T
P
= 95 = 0.73°C/W
130
RTH (j-c) ≤ 0.5°C/W
RTH (c-a) ≤ 0.73°C/W - 0.5°C/W ≤ 0.23°C/W
RECOMMENDATIONS FOR MOUNTING ONTO A HEATSINK
Surfaces in contact must be carefully cleaned.
The heatsink must have an acceptable flatness: from 0.05mm to 0.1mm/100mm.
Roughness of the heater must be around 6.3µm.
In order to improve thermal conductivity, surfaces in contact (alumina, heatsink) are laid on with a silicone grease (type SI 340
from Rhône-Poulenc or Dow 340 from Dow Corning).
Tightening torque on heater: 2 Nm
For the electrical connections, it is recommended to use M4 x 6 screws and if necessary a washer of 1mm thickness. The
recommended screw tightening torque is 1 Nm.
Document Number: 50045
Revision 14-Jan-04
For technical questions, contact sfer@vishay.com
www.vishay.com
29
Share Link: