VP513 데이터 시트보기 (PDF) - SANYO -> Panasonic
부품명
상세내역
일치하는 목록
VP513 Datasheet PDF : 8 Pages
| |||
VP513
Application Notes
Mounting notes:
Since the specified heat sink is required to operate a mounted Video Pack, we recommend the following mounting
technique. (See the thermal design item for details on the required heat sink.) In particular, since the package used for this
product is even more compact than that used in the earlier VPS series, the following points require special care. (These
are recommendations.)
1. A tightening torque of between 0.39 and 0.88 N·m is recommended.
2. The bolt hole spacing in the heat sink should match that of the IC. In particular, the bolt hole spacing should be pulled
in to be as close as possible, within the range that mounting is possible, to the dimensions A and B in the package
dimensions drawing, as shown below.
3. Use either the truss screws (truss bolts) or binding screws stipulated in the JIS standards as the mounting bolts. Also,
use washers to protect the IC case.
4. Foreign matter, such as machining chips, must not be left trapped between the IC case and the heat sink. If grease is
applied to the junction surface, be sure to apply the grease evenly.
5. Solder the IC leads to the printed circuit board after mounting the heat sink to the IC.
Note: The heat sink is absolutely required to operate this Video Pack. Never, in any situation, apply power to a Video
Pack as an independent device. The Video Pack may be destroyed.
No. 5331-7/8
Share Link: 