UDA1342TS 데이터 시트보기 (PDF) - Philips Electronics

부품명

상세내역

일치하는 목록

UDA1342TS

Audio CODEC

Philips Electronics 

This text is here in white to force landscape pages to be rotated correctly when browsing through the pdf in the Acrobat reader.This text is here in

_white to force landscape pages to be rotated correctly when browsing through the pdf in the Acrobat reader.This text is here inThis text is here in

white to force landscape pages to be rotated correctly when browsing through the pdf in the Acrobat reader. white to force landscape pages to be ...

8.16.5 READ CYCLE

The read cycle is used to read data from the internal registers of the UDA1342TS to the microcontroller. The I2C-bus format for a read cycle is shown

in Table 18.

The format of the read cycle is as follows:

1. The microcontroller starts with a START condition S.

2. The first byte (8 bits) contains the device address 001 01X and a write command (bit R/W = 0).

3. This is followed by an acknowledge (A) from the UDA1342TS.

4. The microcontroller then writes the register address where reading of the register content of the UDA1342TS must start.

5. The UDA1342TS acknowledges this register address.

6. Then the microcontroller generates a repeated START (Sr).

7. Again the device address 0011 01X is given, but this time followed by a read command (bit R/W = 1).

8. The UDA1342TS sends the two-byte data with the Most Significant Data (MSD) byte first and then the Least Significant Data (LSD) byte, where

each byte is acknowledged by the microcontroller (master).

9. The microcontroller stops this cycle by generating a negative acknowledge (NA).

10. The UDA1342TS then frees the I2C-bus and the microcontroller can generate a STOP condition (P).

Table 18 Master transmitter reads from UDA1342TS registers

ACKNOWLEDGE FROM UDA1342TS

ACKNOWLEDGE FROM MASTER

DEVICE

ADDRESS

R/W

REGISTER

ADDRESS

DEVICE

ADDRESS

R/W

DATA(1)

S 0011 01X 0 A 0XXX XXXX A Sr 0011 01X 1 A MSD1 A LSD1 A MSD2 A LSD2 A MSDn A LSDn NA P

8 bits

8 bits

8 bits

8 bits

8 bits

8 bits

8 bits

8 bits

8 bits

Note

1. Auto increment of the register address is carried out if repeated groups of 2 bytes are transmitted.

Share Link: